There is nothing better than feeling proud to have completed a DIY project. A circular saw is the best tool to cut pavers. This blog will show you how to use a circular saw to cut pavers in just a few steps. You can read the following information if you are looking to create a new patio, driveway, or make repairs.
How To Cut Pavers Using A Circular Saw?
It is easy to cut pavers using a circular saw. After preparing the paver surface properly, you can simply fix the paver in place with clamps or your fingers. Next, use a circular saw or your hands to cut along the lines that you want to remove. Finally, use a brick-ledge chisel for any remaining paver. Once your cuts have been made, use a sponge to clean the surface of the pavers. Finally, let the paver dry for 24 hours before you try to walk on it again.
-
Draw Your Line
Marking the area you wish to cut pavers using a circular saw is the first step. Begin by adjusting your paver by 3/20 cm from the blade. This will enable you to make two cuts along either side of your paver. This will give you more stability while sawing. Use a crayon or marker to draw your line.
-
Adjust The Height To Your Saw
Adjustable height settings on your circular saw will allow you to adjust the depth of cut. Begin by turning the lowest setting of your circular saw up to 1/10th of an inch higher than the mark you have made on your pavers. Next, adjust the depth of the cut to ensure that the blade cuts just enough to remove any surface above your mark. You can adjust the depth of cut if this bump is greater than 3/20cm. If so, you will continue to increase in increments until you reach the desired setting. After you’re done, turn off your machine and unplug it before proceeding to the next step!
-
You Should Ensure That You Have Enough Space For Your Hands.
Next, ensure that the cutting surface is not too close to the arm of your saw. This will allow you to comfortably cut. Place your thumb close to the edge of the handle (also known as a guard) and adjust your grip. You can experiment with various placements until you find the one that best allows you to control and manipulate your blade. This is where you will learn how to cut pavers using a circular saw!
-
Start Cutting
Making cuts with a circular-saw is the most difficult part. Start by applying a little pressure below the pre-marked line. Next, slowly start to remove the first layer of paver. Continue this process until you have covered the entire paver.
-
Reposition Pavers And Remove Material If Needed
After you have cut your pavers to the desired shape and size, gently wiggle and pull out any extra material with pliers or a Hammer and Chisel. You can remove any surface residue from your pavers by soaking them in water for 10 minutes.
-
Enjoy Your New Pavers
Now that you have learned how to cut pavers using a circular saw, it is time to start enjoying the results of your labour. Relax and enjoy your new patio or driveway. If you need more DIY inspiration, check out this article. This guide will help you install a paver patio.
Tools:
- Circular saw
- Masonry blade or tile blade, if you are only cutting pavers
- Eye protection, ear protection and gloves are all part of safety equipment.
Tip
If you can, use the paver to guide your saw. You can remove any extra material (paver), from the cement base using the brick ledge-chisel. After you have completed this, ensure that there are no uneven surfaces. It is important to avoid tripping on the new pavers. After you have made your cuts, file/sand the edges to prevent injuries.
Final Thoughts
We’ve demonstrated how to cut pavers using circular saws. We also shared some tips and tricks that will make the process as smooth as possible. You should be able complete the task quickly and efficiently if you follow our tips.
